Most of the time, businesses would spend a lot of money to buy their lift trucks. It is important, therefore to take good care of your equipment to protect your investment into the long run. It is really a great idea to know the procedures that are carried out during taking care of and maintaining this machine.
Amongst the best ways to tell how good the engine is performing is by starting the forklift up and listening carefully to see how it runs. Like for example, if there are any knocks or misses, the machine is defective and this should raise some issues. Additionally listen carefully for any squealing sounds which come from the belts as these noises would provide you with a lot of information.
Some of the main components requiring attention during maintenance consist of the horn, safety warning devices, gauges, the overhead guard and the lights. Any burnt out light bulbs or faulty parts have to be replaced as soon as they are noticed. It is also vital to check the wiring.
When the above parts have been inspected thoroughly, proceed to the battery compartment in order to see if the terminals are clean. If the terminals are not clean, be sure to clean them well. Each battery cell should be checked so as to make certain that the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machine and then change the filters. The transmission filter, fuel filters and the hydraulic filter should be replaced on a regular basis. Prior to fitting them, be sure to write the date on the new filters by using a permanent marker in order to keep track.
When the oil change is carried out and the filters have been replaced, a visual inspection of the drive axle has to be carried out. If there is a grease fitting on the axle make sure to apply some grease. Inspect the belts on the engine for any cracks or frays. If you find any, fix the problem accordingly. After that, check each and every other part of the machine including the wheels. If any type of fault or issue is detected, be sure to address it immediately so as to make certain the machine is working at its safest and optimum levels.